行業資訊

攤鋪機使用施工中的注意事項

來源：http://ywsun168.com/ 日期：2022-09-19

在攤鋪機開始施工之前，應該先做一系列檢查，確定大型路面機器設備沒有問題方可開始正常作業，那么攤鋪機在運行的過程中，我們需要具備怎樣的特殊技術要求呢?下面濟南攤鋪機出租廠家一起來看看出租攤鋪機之后施工中的注意事項吧：

Before the construction of the paver, a series of inspections should be carried out to ensure that the large road machinery and equipment are free of problems before normal operation. What special technical requirements do we need to have during the operation of the paver? Now let's take a look at the precautions in the construction after renting the paver from Jinan Paver Rental Factory:

(1)按照施工的嚴格要求，合理確定攤鋪機出租之后的工作速度、攤鋪寬度、攤鋪厚度、刮板輸送器及螺旋分料器轉速、斗門開度等技術參數。

(1) According to the strict requirements of construction, reasonably determine the working speed, paving width, paving thickness, speed of scraper conveyor and spiral distributor, bucket door opening and other technical parameters of the paver after lease.

(2)機械在傳動的瀝青混合料攤鋪機機，換檔一定須在攤鋪機完全停止時進行，并嚴禁用力掛檔。

(2) For asphalt mixture paver driven by machinery, gear shifting must be carried out when the paver is completely stopped, and it is strictly prohibited to shift gears forcibly.

(3)準備卸料時，攤鋪機推輪靠近自卸車后輪，自卸車掛空檔。攤鋪機同時推動兩個。

(3) When preparing for unloading, the pusher of the paver is close to the rear wheel of the dump truck, and the dump truck is in neutral. The paver pushes both at the same time.

(4)攤鋪機的所有部件和系統，必要時應及時協調和校正。運行速度應保持穩定，停車和啟動次數應盡量減少，以保持設備的連續和平衡運行。

(4) All components and systems of the paver shall be timely coordinated and corrected when necessary. The running speed shall be kept stable, and the number of stops and starts shall be minimized to maintain the continuous and balanced operation of the equipment.
濟南攤鋪機出租

(5)嚴禁操作人員在設備作業時離開駕駛臺，無關人員不得在作業時上、下設備，或在駕駛臺上停留。

(5) It is strictly forbidden for operators to leave the bridge during equipment operation, and irrelevant personnel shall not get on or off the equipment or stay on the bridge during operation.

(6)攤鋪機轉場后若是在行駛的過程中，禁止在坡道上換檔，或空檔下坡滑行。攤鋪作業前20-40min，對熨平板進行預熱，使其接近瀝青混合料的攤鋪溫度;因故暫停作業時，使用預熱系統進行保溫，防止熨平板冷卻;用電預熱時，應先啟動發動機。

(6) After the paver is transferred, if it is driving, it is forbidden to shift gears on the ramp or slide downhill in neutral. 20-40min before paving, preheat the screed to make it close to the paving temperature of asphalt mixture; When the operation is suspended for some reason, the preheating system shall be used for heat preservation to prevent the screed from cooling; When preheating with electricity, start the engine first.

此外清潔攤鋪機，除去攤鋪機表面堆積的泥塊、粘沙和瀝青等；清除發動機、液壓元件和其他部件表面上的塵土、油垢。注意，切勿將污物弄進各加油口和空氣濾清器內。更多注意事項就來我們網站http://ywsun168.com咨詢吧！

In addition, the paver shall be cleaned to remove the mud lumps, sticky sand and asphalt accumulated on the surface of the paver; Clean the dust and oil dirt on the surface of the engine, hydraulic components and other components. Be careful not to get dirt into the oil filler and air filter. More notes on our website http://ywsun168.com Consult!

上一條：水穩和混凝土的區別

下一條：修路用的瀝青到底是什么